Details

---

MB5B Tester Bag
VPP10531
The MB5B Tester Bag is an extra large and highly-configurable front accessed bag designed for a Multifunction Tester (MFT).

PRODUCT SPECIFICATIONS:
Height (H): 15” (38cm)
Width (W): 15" (38cm)
Depth (D): 10" (25.5cm)
Weight (empty): 9lbs/4kg
Internal Volume: 840 in3/ 14L
Max Payload: 45lbs/20kg

MAXIMIZED TOOL STORAGE CAPACITY:

• 21 exterior tool pockets
• Rear padded tablet computer pocket: 11"(H)  x 10" (W)  x  1" (D)
• Detachable/optional backpack straps
• 2 padded side-mounted meter or tool pockets with repositionable interior pockets
• V-SWAP™ removable component system - choose from several included or optional panels
• Removable storage box & adjustable height shelf for accommodating a Multifunction Tester
• Pair of 8in/20cm magnetic parts bags for leads and fittings
• “Hang-up” hook - accessible while open and closed
• Over-molded rubber grip
• 8" electrical tape strap
• Polypropylene plastic base for moisture and abrasion protection

OTHER FEATURES:
Warranty: 5 Years (see Veto warranty terms and conditions)
MB5B TESTER BAG PRODUCT SHEET

Additional Information
VETO PRO PAC TOOL BAGS PRODUCT CARE AND MAINTENANCE

• Keep the Zippers Clean & Lubricated
• Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
• Protect the Zippers From Sharp Objects and/or Excessive Heat
• Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
• Don’t Overstuff the Bag
• Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!